BFI MK3 Motor Mount Spacers


BFI MK3 Motor Mount Spacers - Click to enlarge
BFI MK3 Motor Mount Spacers - Click to enlarge
Item# EBFI70039623
$79.99

PRODUCT DESCRIPTION

BFI MK3 Motor Mount Spacers

Tired of smashing those expensive oil pans on your MK3? Looking to gain a bit of extra clearance, but don't want to raise your car up? These engine mount spacers are the perfect option as they are a simple and quick install that give you an additional 17mm of clearance.

Sold as a kit of 3, these spacers install between your engine mounts and your engine mount brackets and are fastened with included longer, and most importantly, upgraded 10.9 hardware. These spacers are also fully clear anodized for corrosion resistance and long lasting durability. Our spacers will last a lifetime.

INCLUDES:
  • Three 17mm spacers - front, rear and trans
  • Upgraded 10.9 hardware

FITS:
  • MK3 Golf/Jetta

NOTES:
  • Upgraded motor mounts are highly recommended when uses these spacers.
  • In most applications the hood will close without modification but in some instances hood liner will need to be trimmed.
  • Vehicles that are significantly lower than stock may experience the axles hitting the frame when using these spacers.

Below, you can see an after shot of our MK3 motor mount spacers installed and just how much higher the engine sits- almost flush with the subframe

Installing BFI MK3 Motor Mount Spacers


This is a side profile shot from the passenger fender showing just how much the engine is raised. In most applications the hood will close without modification but in some instances hood liner will need to be trimmed.

Installing BFI MK3 Motor Mount Spacers


A look at the location of installation for the rear engine mount on a MK3 Installing BFI MK3 Motor Mount Spacers